Rome to Milan Dual BIOS update SOP

1.Use Rome CPU to boot up.

 * If no Rome CPU, please install each one of the supported CPUs

   and plug in the power cable. The BMC LED will light up once the              

   on-board BMC is active. Please go to router/switch to get DHCP

   to assign IP to login WEBUI.

2.   Log-in WEBUI to update BMC with FW 2.3.1

      a. Choose “Maintenance” and then “firmware Update”

2.   Log-in WEBUI to update BMC with FW 2.3.1

      b. Choose BMC FW 2.3.1 file to Start firmware update 

<BIOS and BMC FW version may vary by different models >

3. Upon BMC FW completion, log-in WEBUI again and use

    BIOS update function to update BIOS 0201 with CAP file

    a. Choose “Maintenance” and then “BIOS Update”

3. Upon BMC FW completion, log-in WEBUI again and use

     BIOS update function to update BIOS 0201 with CAP file

     b. Choose MILAN BIOS 0201 to start BIOS update

<BIOS and BMC FW version may vary by different models >

4.  Upon BIOS completion, shut down and reboot

5.  Now the motherboard is with BIOS 0201 and is able to

       boot up with both Milan and Rome CPU

<BIOS and BMC FW version may vary by different models >

Notice

Above information might be partly or entirely quoted from exterior websites or sources. please refer to the information based on the source that we noted. Please directly contact or inquire the sources if there is any further question and note that ASUS is neither relevant nor responsible for its content/service.
This information may not suitable for all the products from the same category/series. Some of the screen shots and operations could be different from the software versions.
ASUS provides the above information for reference only. If you have any questions about the content, please contact the above product vendor directly. Please note that ASUS is not responsible for the content or service provided by the above product vendor.